HP Digital Sender 8100C Administrator's Manual page 35

34
Revision page parameters
Parameter
Box Version #
FW Ver.
FW Date
HP JetDirect Prd. #
HP JetDirect FW
Rev.
MAC Address
IP Address
Subnet Mask
TCP/IP status
Gateway Addr.
Received pkts
Bad packets
Framing err.
Transm. pkts
Collisions
Late collisions
All manuals and user guides at all-guides.com
Descriptions
Product version
Version of firmware installed in the digital sender.
Release date of the firmware installed in the digital sender.
Product number of the network interface card:
HPJ3113A
Ethernet (10Base-T) networks
Version of firmware installed on the network interface card
(G. xx.xx ).
Unique LAN hardware address assigned to the network
interface card at the time of manufacture (for example,
0060B072525E).
Unique TCP/IP address of the network interface card. This is
assigned by the administrator.
If subnets are used, the filter used to identify the subnet of the
HP JetDirect print server (network interface card). This is
assigned by the administrator.
Status of the connection to the network:
INITIALIZING
The network interface card is searching for a valid IP address. After 2
minutes, a default IP address is automatically assigned.
READY
The network interface card has been assigned an IP address and is
actively connected to the network.
ERROR
A network or network interface card error has been detected.
IP address of the default gateway server used to communicate
with nodes on other subnets or networks.
Total number of packets received without error.
Total number of packets received with errors.
Total number of packets received that contained a CRC (cyclic
redundancy check) or framing (alignment) error.
Total number of packets transmitted without error on the
network.
Total number of packets that were not transmitted due to
successive collisions.
Total number of packets that were not transmitted due to late
collisions (collisions after the 64th byte of a packet).