Bosch Rexroth IndraControl S67 Manual page 73

DOK-CONTRL-S67DIO8M12*-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Inputs/Outputs – 0.5 A (8×M12)
Position LED Color/status
15 SB Green, flashing
1 Hz
Green, flashing
2 Hz
Position LED Color/status
16 F Red
17 I/O Yellow
Red
Position LED Color/status
18 U Green
A
Off
19 U Green
LS
Off
Cause
Module in HOLD state
The module is in STOP state
Tab. 11-1: Operating messages 1
Cause
At least one global
diagnostic message occurred at
module
Input or output signal present
Error at output
Tab. 11-2: Operating messages 2
Cause
Sensor/actuator supply U
Sensor/actuator supply U
present
Logic supply U
LS
Logic supply U
LS
Tab. 11-3: Operating messages 3
Bosch Rexroth AG
Diagnostics via LED Signals
Remedy/information
Initiated by field bus coupler.
In DI mode, the last input values
transmitted to field bus coupler are
retained in the process image.
The last output values are main‐
tained in DO mode
Initiated by field bus coupler.
In DI mode, the input values are set
to "0" in the process image
In DO mode, "0" is output as output
value
Remedy/information
Check supply voltages U
of upstream IndraControl S67 com‐
ponents. Also refer to
"Diagnostic Overview" on page 45
–
Check actuator connection for short
circuit or overload. Short circuit or
overload is only diagnosed if the
output is enabled
Remedy/information
present –
A
not Connect supply voltage and check
A
voltage level if required
present –
not present Connect supply voltage and check
voltage level if required
71/93
and U
LS A
chapter 8.2