Operational Precautions; Laser Handling Precautions; Preventing Electric Shock; Electromagnetic Compatibility (Emc) - FujiFilm FCR XG-1 Operation Manual

Introduction
1.2

Operational Precautions

1.2.1 Laser Handling Precautions

Class
Medium
Wavelength
Maximum Output
WARNING: The CR-IR346RU incorporates a Class IIIb laser with maximum output of 50mW.
CAUTION: Use of controls or adjustments or performance of procedures other than those

1.2.2 Preventing Electric Shock

WARNING: High voltage is supplied to the photomultiplier.
WARNING: The power supply to the unit is AC 100-120 / 200-240 V. To prevent electric shock,

1.2.3 Electromagnetic Compatibility (EMC)

The CR-IR346RU system complies with the standards for EMC that are applied in various
countries as follows.
• IEC60601-1-2: 1993 (Japan)
• FCC Rules Part 15, Class A (USA)
• EN60601-1-2 (Europe)
WARNING: Electromagnetic wave-sensitive parts, such as the FDD, HDD, photo-
010-021-20 09.2001
CR-IR346RU Laser Unit Specifications
IIIb
Semiconductor laser
660 nm
50 mW (CW)
To prevent exposure to its laser beams, observe the following precautions.
• Never open or remove the protective covers.
• Always contact a qualified service engineer immediately if you suspect there is a
malfunction.
specified herein may result in hazardous radiation exposure.
To prevent electric shock, please observe the following precaution.
• Never remove the protective covers from the unit.
please observe the following precautions.
• Avoid installation sites where the equipment will be exposed to water.
• Always ground the equipment to a protective earth line.
• Make sure that all connections are secure and connected correctly.
multiplier, etc., are used in this equipment.
Do not place any objects that emit strong electromagnetic waves near
the equipment.
1
2
3
A
B
C
Y
Z
1-3