FujiFilm FCR XG-1 Operation Manual page 64

Exposed Anatomical Regions/Applicable Menus/Display Parameters
[ Chest 2 ]
(PA) : Right-to-left
STERNUM
1 2202
THORA. SPINE, FRN
2203
1
THORA, SPINE, LAT
1 2204
SHOULDER JOINT
1 2205
CHEST, SPECIAL-1
2 0210
CHEST, SPECIAL-2
2 0220
CHEST, PED.-1
2 0217
CHEST, GENERAL-2
2 020E
CHEST, PORTABLE
020F
2
THORA. SPINE, OBL
2 0211
CHEST, MYELO., FRN
2 1205
CHEST, LYMPHA, FRN
2 1206
CHEST, MYELO., LAT
2 1204
CHEST, LYMPHA, LAT
2 1207
SHLD, JNT, ARTHRO
2 1208
CHEST, MAG
2 4208
Y-10
Menu
Applicable projection method
reversed output
Sternal tomography
:T
(AP)
Thoracic spinal tomography
:T
(AP)
Thoracic spinal tomography (this menu is used when
:T
the enface radiogram is different in density from the
(AP)
oblique radiogram)
Tomography of the shoulder joint and its periphery
:T
brachial region
(AP)
For pneumoconiosis diagnosis
(PA)
For mass radiography
(PA)
Low-dose plain thoracic exposure in infants
(AP)
Observation of a thin shadow in the lung field
(infiltrative alveolar shadow)
(PA)
Observation of chest for prognosis
(AP)
Observation of thoracic spine in oblique radiogram
(PA)
Exposure with a contrast medium of the spinal canal
:C
and intervertebral discs of the thoracic spine
(AP)
Thoracic lymphatic duct and lymph node exposure
:C
with a contrast medium
(AP)
Exposure with a contrast medium of the spinal canal and
:C
intervertebral discs of the thoracic spine (this menu is used
when the enface radiogram is different in density from the
(AP)
oblique radiogram)
:C Thoracic lymphatic duct and lymph node exposure with a
contrast medium (this menu is used when the enface radiogram
(AP)
is different in density from the oblique radiogram)
Shoulder joint exposure with a contrast medium
:C
(AP)
3× or more magnification of the lung field, thoracic
:M
lymphoduct, and other sites
(AP)
and observation site
Remarks
For tomography of the cervicothoracic
spines, use the 2500 "LUMBAR SPINE"
menu.
For tomography of the cervicothoracic
spines, use the 2500 "LUMBAR SPINE"
menu.
Load the system with the display
parameters usually considered
appropriate for coniosis staging.
Load the system with the display
parameter considered fit for screening.
Use a grid.
010-021-20 09.2001