FujiFilm FCR XG-1 Operation Manual page 15

Introduction
[ Table 1-1 ] FCR XG-1 Component Names and Functions
Name
Operation Panel
POWER Lamp
PRIMARY/SECONDARY
Erasure Selection Switch
CALL Lamp
Cassette Ready
Lamp
Progressing Status
Lamps
Cassette Removal
Lamp
CR Console
Cassette Insertion Unit
Air Filter
Circuit Breaker
Reset Switch
010-021-20 09.2001
Function
Operation panel for the CR-IR346RU.
Lights (green) when the circuit breaker has been set to the "I" side and the
power turned ON. As the circuit breaker is basically left ON, the POWER Lamp
will also basically be lit.
When you wish to conduct Primary or Secondary erasure to the cassette (IP),
press this key to enter each mode. If this key is pressed once, the Secondary
erasure will be selected and its icon mark (
again, the Primary erasure will be selected and its icon mark (
highlighted. To return to the routine reading mode in this stage, press the key
once again. As the mode selection operation procedure indicates, the key is
designed with the toggle system as follows.
Routine Reading mode Secondary Erasure mode
When the CALL Lamp lights (yellow), a pop-up window will appear on the
screen of the CR Console. Do as the message in the window instructs. When
the pop-up window is closed, the CALL Lamp will go OFF.
Lights (green) when the device has started up normally, indicating that
cassette can be inserted. Cassette cannot be inserted when the lamp is OFF.
Indicates the IP processing status.
Lights (green) when the processed cassette can be removed.
Inputs exposure information, displays images and operates QA. For detailed
operation procedures, see the [CR Console Operaiton Manual].
Used for inserting cassette that contains an exposed IP.
Installed at the inlet of the ventilation fan.
Should be left turned ON.
Used only to reboot the CR-IR346RU. Never press this switch unless for error
recovery processing.
). If this key is pressed once
) will be
Primary Erasure mode
1
2
3
A
B
C
Y
Z
1-9