Connecting The P-73X To The Electronics - PI P­73 Series User Manual

5 Installation
Requirements
 You have read and understood the general notes on installation (p. 19).
 The P-73x is not connected to the electronics.
Tools and accessories
Screws of suitable size and length (p. 43)

Suitable screwdriver

Fixing the load
1. Align the load on the P-73x so that the mounting holes in the load and the holes in the
platform are in line.
2. Hold the load so that it cannot move while tightening the screws.
3. Fix the load by tightening the screws in the mounting holes (p. 43) provided. Pay
attention to the specified torque range (p. 48) for the screws.
4. Check that the load is sitting firmly on the platform.
5.5 Connecting the P­73x to the Electronics
INFORMATION
 When connecting, pay attention to the assignment specified on the labeling of the sockets,
plug connectors, and cables.
Requirements
 You have read and understood the general notes on installation (p. 19).
 You have installed suitable electronics (p. 13).
 You have read and understood the user manual for the electronics.
 The electronics are switched off.
Tools and accessories
If intended for your system: Adapter cable (p. 14)

Connecting the P­73x to the electronics
1. If adapter cables are intended, connect the adapter cable to the P-73x.
2. Connect all of the P-73x's connectors (or the adapter cable connected to it) to the
electronics (refer to the user manual for the electronics).
3. If possible, secure the connector(s) against accidental disconnection.
P­73x Nanopositioner PZ103E Version: 1.1.0 25