User Manual
O O u u t t e e r r d d i i a a m m e e t t e e r r D D ( ( m m m m ) )
30~40
40~50
step 3 Strip the protection layer and insulation layer by specific length, as described in the fig-
ure below.
step 4 Make the cable and crimp OT/DT terminal,refer to
step 5 Unfasten the buckle and remove the protective cap.
step 6 Secure the wires to corresponding terminals.
Observe the terminal layout on the block. Do not connect the phase wires to
"PE" terminal or PE wire to "N" terminal. Otherwise, unrecoverable damage to
the inverter may follow.
S S e e a a l l s s
a+b
a
" Crimp OT/DT
5 Electrical Connection
terminal".
33