4. Mount the fl ap servo in the wing. Remove the servo
screws and harden the holes with thin CA. Then, reinstall
the servo screws.
5. We used a two-position switch with the end points or
travel set 50% in both directions. Switch on the transmitter
and receiver. Set the fl ap control switch to the "fl ap up"
position. Install the fl ap servo arm as shown.
6. Align the fl ap with the aileron and install the fl ap
pushrod, following the same procedure used to install the
aileron pushrods.
7. Return to step 1 and install the fl ap servo in the right
wing. Note: If a Y-harness will be used to connect the two fl ap
servos, the servo arms must be pointing in the same direction.
Install the Wing Dowels
1. Glue the wing joiner dowel into one wing panel. Slide
both wing halves together slightly to align the pin. Don't glue
the wing panels together.
2. Install the two wing dowels.
13