GREAT PLANES GIANT BIG STIK XL 55-61cc/EP ARF Instruction Manual page 19

5. Insert the rudder and elevator pushrods.
6. Install the rudder and elevator servos. After installing
the servo screws, remove them and apply a drop of thin CA
in each hole. After the CA cures, reinstall the screws.
7. Connect the servos to the receiver and center the servos.
Basic and Advanced Set-up: Plug the servos directly into
the receiver.
S.Bus with non S.Bus servos: Set the channels to 2 and 4 on
a 400mm Decoder. Connect the elevator to channel 2 and the
rudder to channel 4. Plug the Decoder into the Terminal box.
S.Bus with S.Bus servos: Program the servos and plug both
servos into the Terminal box.
8. Install the rudder and elevator control horns and clevises
following the same procedure used to install the aileron
pushrods.
19