Battery Precautions/Connecting Batteries; Check The Control Directions; Set The Control Throws - GREAT PLANES Cherokee .40 ARF Instruction Manual

Battery Precautions/Connecting Batteries

This is how to connect four batteries in Series:
Connecting batteries in "Series" means to connect the +'s
to the –'s and the –'s to the +'s. This combines the batteries'
voltages, but the capacity remains the same.
This is how to connect three batteries in Series:
Batteries of different voltages, but not different capacities
may also be connected in Series:

Check the Control Directions

❏
1. Turn on the transmitter and receiver and center the
trims. If necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall the
screws that hold on the servo arms.
❏
2. With the transmitter and receiver still on, check all the
control surfaces to see if they are centered. If necessary, adjust
the clevises on the pushrods to center the control surfaces.
❏
3. Make certain that the control surfaces and the carburetor
respond in the correct direction as shown in the diagram.
If any of the controls respond in the wrong direction, use
the servo reversing in the transmitter to reverse the servos
connected to those controls. Be certain the control surfaces
have remained centered. Adjust if necessary.

Set the Control Throws

Use a Great Planes AccuThrow
measure and set the control throw of each control surface
as indicated in the chart that follows. If your radio does not
have dual rates, we recommend setting the throws at the low
rate setting.
23 23
™ (or a ruler) to accurately