Select Paper Type - Brother MFC-730 Owner's Manual

94
C H A P T E R E L E V E N

Select Paper Type

1
Press Menu, 3, 1. The screen displays
1.PAPER TYPE
2
Press Set.
3
Press or to select your paper setting.
PAPER:PLAIN
PAPER:INK JET
PAPER:GLOSSY
PAPER:TRNSPRNCY
4
Press Set when the screen displays your selection.
If you use Brother coated paper for 360 dpi (BP36CA) or 720 dpi
(BP72CA), select INK JET, then select 360DPI or 720DPI. If you use
non-Brother ink jet paper, select INK JET, then select OTHER. If you
did not select INK JET, skip to step 7. (For information on ordering
Brother paper, see the page before the Table of Contents.)
5
Press or to select 360DPI, 720DPI, or OTHER.
6
Press Set.
7
Press Stop to exit.
The MFC ejects paper with printed surfaces face up into the paper tray at
the front of the MFC. When you use transparencies, remove each sheet
immediately, to prevent a paper jam or curled sheets.
(This is a permanent setting)