Brother MFC-730 Owner's Manual page 32

20
C H A P T E R T W O
11
Press 1 on the dial pad for each colour, as prompted (for initial setup
only) within 1 minute. The MFC will enter a cleaning cycle for
approximately 6 minutes. The screen alternately displays
CLEANING BLACK and PLEASE WAIT. The ink dot counter
will be set automatically for each colour, so the MFC can warn you
with an error message when ink is running low.
Make sure paper is loaded in the cassette, then press Start within 1
minute.
When the MFC completes the cleaning cycle, the MFC starts
printing the test sheet.
12
Only during initial ink cartridge installation, the screen shows.
PRINT OK?
1.YES 2.NO
Check the print quality of the test sheet. If it is not good, clean the
print head again, by pressing 2. The screen will ask you if the print
quality is OK for each colour. Press 2 for any colour with a problem.
You can choose several colours. After cleaning is finished, press
Start.
The MFC starts printing Test Sheet No. 2.
13
Adjust the Vertical Alignment by following the instructions printed
on the Test Print page.
WARNING
If ink gets in your eyes, flush them with water immediately and seek
medical attention if required.
Caution
DO NOT remove ink cartridges if you do not need to replace them.
If you do so, it may reduce the ink quantity and the MFC will not
know the quantity of ink left in the cartridge.
DO NOT shake the ink cartridges. If you do so, the ink may spill
when you take off the sealing tape. If ink stains your body or
clothing, wash with soap or detergent immediately.
If you install an ink cartridge in the wrong colour position, you must
clean the print head several times after correcting the cartridge
installation and before you start printing because the colours were
mixed.