Tightening Torques; Electrical Installation - Danfoss VLT FC 103 Instruction Manual

Installation
NOTICE!
Backplate is needed when mounted on railings.
2 2

2.3.4 Tightening Torques

See chapter 10.4 Connection Tightening Torques for proper tightening specifications.

2.4 Electrical Installation

This section contains detailed instructions for wiring the adjustable frequency drive. The following tasks are described:
•
Wiring the motor to the adjustable frequency drive output terminals
•
Wiring the AC line power to the adjustable frequency drive input terminals
•
Connecting control and serial communication wiring
•
After power has been applied, checking input and motor power; programming control terminals for their intended
functions
10
Instruction Manual
Danfoss A/S © Rev. 2014-02-10 All rights reserved. MG16E222