Danfoss VLT FC 103 Instruction Manual page 24

Installation
2.4.5.1 AC Line Input Connection for A2
and A3
1. Mount the two screws on the mounting plate
2 2
2. Slide the mounting plate into place and tighten
fully
Figure 2.20 Mounting Plate Position
20
Instruction Manual
The ground connection cable cross-section must be at
least 0.016 in
terminated separately according to EN 50178/IEC
61800-5-1.
Danfoss A/S © Rev. 2014-02-10 All rights reserved.
3. Mount and tighten ground cable
Figure 2.21 Ground Cable Mounting
WARNING
2 2
[10 mm ] or two rated line power wires
MG16E222