Motor Connection For A4 And A5; Motor Connection For B1 And B2 - Danfoss VLT FC 103 Instruction Manual

Installation
2. Mount cable clamp to ensure 360° connection
between chassis and shield, note the outer
insulation of the motor cable is removed under
the clamp.
2 2
Figure 2.15 Cable Clamp Mounting

2.4.4.2 Motor Connection for A4 and A5

1. Terminate the motor ground
2. Place motor U, V and W wires in terminal and
tighten
3. Ensure that the outer insulation of the motor
cable is removed under the EMC clamp
Figure 2.16 Motor Connection for A4 and A5
18
Instruction Manual

2.4.4.3 Motor Connection for B1 and B2

- LC -
Danfoss A/S © Rev. 2014-02-10 All rights reserved.
1. Terminate the motor ground
2. Place motor U, V and W wires in terminal and
tighten
3. Ensure that the outer insulation of the motor
cable is removed under the EMC clamp
Figure 2.17 Motor Connection for B1 and B2
MG16E222