Table of Contents
Advertisement
Copyright © 2018, Juniper Networks, Inc.
I2C Bus test
I2C Bus test completed, 1 pass, 0 errors, 0 warnings
PCIe Interface test
PCIe Interface test completed, 1 pass, 0 errors, 0 warnings
IDP Interface test
IDP Interface test completed, 1 pass, 0 errors, 0 warnings
HWA Memory (Short MemWalk: 00000000-04000000) test
HWA Memory (Short MemWalk: 00000000-04000000) test completed, 1 pass, 0 errors,
0 warnings
HWA Memory (Short MemAddr: 00000000-04000000) test
HWA Memory (Short MemAddr: 00000000-04000000) test completed, 1 pass, 0 errors,
0 warnings
HWA Packet test
HWA Packet test completed, 1 pass, 0 errors, 0 warnings
Sensor test
Sensor test completed, 1 pass, 0 errors, 0 warnings
Temp near FPGA
| 29 degrees C
Temp near NPU
| 25 degrees C
Temp near SFP3
| 23 degrees C
Temp near SFP0
| 25 degrees C
FPGA +3.3V
| 3294 millivolts
VDD +3.3V
| 3294 millivolts
0.9V OK
| 0
1.8V OK
| 0
1.2V OK
| 0
1.1V OK
| 0
1.0V OK
| 0
NPU Tj
| disabled
NPU Tj: / 34C
IPMC test
IPMC test completed, 1 pass, 0 errors, 0 warnings
Booting...
Booting /kernel ...
For normal operation, allow the autoboot to proceed. Do not press any key when you get
the
Hit any key to stop autoboot:
Full POST diagnostics then run, and the system starts Junos OS normally. If detailed
diagnostics must be run, or if alternate media (for example, a USB storage device) must
be booted, press any key before or during the 1-second countdown. The following
bootstrap prompt is displayed:
BOOT>
If POST diagnostics or the bootstrap sequence fails, the bootstrap prompt is displayed
again, and the front panel LED lights turn red.
Chapter 9: Connecting the Router to Power
| OK
| OK
| OK
| OK
| OK
| OK
| Asserted
| Asserted
| Asserted
| Asserted
| Asserted
| NS
message.
49
Advertisement
Table of Contents
Troubleshooting
