Juniper LN2600 Manual page 62

LN2600 Rugged Security Router
48
Boot flash: 16 MB @ 0x1fc00000
IDE flash: 3.7 GB (7946064 x 512)
USB: not available
current_dev: ide
coremask: 0xfff (12 cores)
reset: Hard
NVMRO: Write-enabled
watchdog: Armed
FPGA: Enabled
Firmware Image Status:
Primary Bootstrap: UP TO DATE
Secondary Loader0: UP TO DATE
Secondary Loader1: UP TO DATE
IPMC Firmware: UP TO DATE
IPMC_RB Firmware: UP TO DATE
Hit any key to stop autoboot:
Checking firmware for updates...
IPMC test
IPMC test completed, 1 pass, 0 errors, 0 warnings
********************************
POST
********************************
CPU BIST test
CPU BIST test completed, 1 pass, 0 errors, 0 warnings
CPU Core (0ffe) test
CPU Core (0ffe) test completed, 1 pass, 0 errors, 0 warnings
CPU GPIO test
*** Warning during CPU GPIO test, pass 1,
NVMRO not asserted, verify error at location 0x8001070000000880, expected 0x0002,
actual 0x0000, Slot 0 (Signal ref. des. NVMRO[A4])
CPU GPIO test completed, 1 pass, 0 errors, 1 warning
CPU Memory (Post: 00080000-0effffff) test
CPU Memory (Post: 00080000-0effffff) test completed, 1 pass, 0 errors, 0 warnings
CPU Memory (Post: 20000000-7fffffff) test
CPU Memory (Post: 20000000-7fffffff) test completed, 1 pass, 0 errors, 0 warnings
CPU Memory (Post: c0000000-cfffffff) test
CPU Memory (Post: c0000000-cfffffff) test completed, 1 pass, 0 errors, 0 warnings
Juniper ID EEPROM test
Juniper ID EEPROM test completed, 1 pass, 0 errors, 0 warnings
SysFlash test
SysFlash test completed, 1 pass, 0 errors, 0 warnings
0
Copyright © 2018, Juniper Networks, Inc.