Figure 20: Ln2600 Router With Top Cover Panel Open - Juniper LN2600 Manual

Copyright © 2018, Juniper Networks, Inc.
Pass the interface cable bundle through the interface cable entrance.
5.
At the power cable entrance, tighten the power cord screw to seal the power cord.
6.
Close the top cover panel, and secure it with three latches (see
7.
For enhanced security you may secure the latches with locks. This precaution ensures
that the router is accessible only to authorized personal.
NOTE: When closing the top cover, make sure that the rubber gasket
present on the top of the cable cover unit is properly placed on the grooves.
This rubber gasket prevents water and dust from entering the LN2600
router unit.

Figure 20: LN2600 Router with Top Cover Panel Open

1— Top cover panel
2— Protective rubber gasket
Pass the interface cables that are coming out of the interface cable entrance through
8.
the grooves present in the cable seal unit.
The cable seal is a small circular-shaped foam structure with grooves for the cables
to pass through. The cable seal sits tightly on the interface cable entrance and prevents
water and dust particles from entering the cable management system.
NOTE: Ensure that each groove on the foam cable seal unit accommodates
only one cable through it.
Chapter 10: Installing Components
Figure 3 on page
3— Status LED
4— Bottom cable management unit
5).
N T Y
W A R R A
R EM O V ED
V O ID IF
55