Replacing Components; Removing The Ln2600 Router - Juniper LN2600 Manual

Rugged security router

Hide thumbs Also See for LN2600:

Table of Contents

CHAPTER 12

Replacing Components

Removing the LN2600 Router on page 63

Removing the SFP Transceiver from the LN2600 Router on page 64

The interface cables on the LN2600 router are hot-swappable; power can be left on

while you remove or replace a cable without damaging the router.

Ensure that you have the following parts and tools available:

A 3/32 in Allen wrench with a torque of 5 lb-in (0.56 Nm).

Phillips (+) screwdriver

An electrostatic discharge (ESD) grounding strap

CAUTION:

The LN2600 router has more than one power source. Ensure

proper care while disconnecting the DC power supply to the router.

To remove the router from the 19 in. rack:

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to one of the ESD points on the chassis.

Using the screwdriver, loosen the four cage nuts from the front and from the rear of

the rack that hold the LN2600 router.

Ensure that you hold the router from the bottom for support before loosening the

nuts.

Hold the LN2600 router from the bottom to support it, and pull it completely out of

the rack.

Table of Contents