Table of Contents
Advertisement
Remote Control
This section contains information for remotely controlling the DTP2 T 202 FB switching
transmitter. Topics in this section include:
•
•
•
Host Control Ports
The transmitter is remotely controllable via its side panel Remote RS-232 port ("Serial Port"
below) or top panel Configuration (USB) port (see "USB Port" below).
The Remote RS-232 port and Configuration port are independent of one another. A Remote
RS-232 port connection and a Configuration port connection can be active at the same
time.
Serial port
The side panel Remote port is an RS-232 serial port on a 3-pin captive screw connector
(see
The serial port protocol of the side panel Remote RS-232 port is:
•
•
USB port
The top panel Configuration port
cable, terminated on one end with a USB mini-B male connector, is available at any local
electronics store.
Host Control Ports
Simple Instruction Set Control
Product Configuration Software Control
item B
on page 8).
9600 baud
•
No flow control
•
No parity
•
1 stop bit
(item A
on page 11) is a standard USB port. A USB
DTP2 T 202 FB • Remote Control
8 data bits
20
Advertisement
Table of Contents
