Table of Contents
Advertisement
Switch Modes
The switching transmitter has three switch modes:
•
•
•
These modes can be selected through SIS commands (see
on page 22) or the Product Configuration Software (see the PCS Help file).
EDID
To manage EDID on the DTP2 T 202 FB, use the Product Configuration Software (see
Product Configuration Software Help file).
Reset Mode
Use the recessed Reset button on the top panel of the transmitter (see
page 11) to initiate two levels of reset as follows:
Reset to factory default condition — Cycle unit power off and on while holding the
Reset button. All top panel LEDs cycle. Release the button.
Reset to default settings — Press and hold the reset button for approximately 6
seconds. All top panel LEDs cycle. Release the button. This reset is the equivalent of issuing
the
Troubleshooting — If no Image Appears
1.
2.
3.
4.
5.
Manual — The input must be selected manually using an SIS command
Auto switch (DisplayPort) — The switcher automatically selects the input with an
active signal present and, if both are present, prioritizes the DisplayPort input. This is the
factory default mode.
Auto switch (HDMI) — The switcher automatically selects the input with an active
signal present and, if both are present, prioritizes the HDMI input.
E
Reset
SIS command (
ZXXX
Ensure that all devices are plugged in and powered on. The switcher is receiving power
if one of the input LEDs is lit.
Ensure an active input is selected on the switcher or that the switcher is in auto-input
switching mode.
Ensure that the proper signal format is supplied.
Check the cabling and make corrections as necessary.
Call the Extron S3 Sales & Technical Support Hotline if necessary (see
www.extron.com
for the phone number in your region of the world).
Switch mode
}
, see page 25).
DTP2 T 202 FB • Installation and Operation
SIS commands
item
on
B
19
Advertisement
Table of Contents
