Top Panel Features; Mounting - Extron electronics DTP2 T 202 FB User Manual

Top Panel Features

A
B

Mounting

Before mounting the floor box, consider the mounting location and prepare the surface as
necessary.
1.
2.
3.
Config(uration) port — Connect a host
device to the top panel mini USB B
configuration port. This port serves a similar
communications function as the side panel
Remote RS-232 port, but it is easier to access
than the side port after the switcher has been
installed and cabled.
NOTE: A top panel Configuration port
connection and a side panel Remote
RS-232 port connection can both be active
at the same time. If commands are sent
simultaneously to both, the command that
reaches the processor first is handled first.
Reset button — Initiates two levels of
switcher reset. For the different reset levels,
press and hold the button while the
switcher is running or while you power up the
Reset Mode
switcher (see
details).
If not already completed, install the appropriate adapter plates in the desired position
and mounting slots (see Adapter Plates
Align the screw holes on the DTP2 T 202 FB with the screw holes on the adapter
plates.
Using the provided self-threading screws and washers, secure the DTP2 T 202 FB to
figure 11
the adapter plates (see
CONFIG
RESET
on page 19 for
Figure 10.
on page 5).
figure 14
though beginning on page 12).
DTP2 T 202 FB • Installation and Operation
w
DTP2 T 202 FB
HDMI IN AUDIO IN DISPLAYPORT IN
HDMI
DP
SIGNAL
HDCP
AUTO
CONFIG RESET
A
B
Top Panel Features
11