Specifying Trace Route Settings - JDS Uniphase HST-3000 User Manual

Specifying trace
route settings
4 Select DNS Name, and then enter the DNS name.
5 Select Number Pings, and then set the number of pings
to send before stopping.
6 Select Pings/second, and then set the number of pings
per second.
7 Select Packet size, and then set the packet size.
The default is 16. Change this only if needed.
The ping settings are specified.
The following procedure describes how to specify the trace
route settings. For all modes except TE mode, the WAN inter-
face is the DSL connection to tip and ring.
To specify the trace route settings
1 Press the Trace Route soft key. You may need to use the
left or right arrow key to find the TRACERT soft key.
The Trace Route Settings menu appears.
2 Select Address Type, and then select either IP address
or DNS Name (domain name server name).
3 Select IP Address, and then enter the IP address.
4 Select DNS Name, and then enter the DNS name.
HST-3000 VDSL Testing User's Guide
Chapter 2 VDSL Testing
Testing Data services
47