Specifying Data Settings - JDS Uniphase HST-3000 User Manual

Specifying data To use ping, trace route, FTP/HTTP, or the web browser, the
settings data configuration must be set correctly.
Be sure to check these settings before you proceed with test-
ing. Check the trouble ticket or call your help desk for assis-
tance.
The following procedure describes how to specify the data
settings.
To specifying the DATA settings
1 Press the Configure
2 Select the DATA soft key.
3 Select Data Mode and then choose a mode.
HST-3000 VDSL Testing User's Guide
NOTE:
You may achieve synchronization with the DSLAM without
configuring these settings, but you must configure these to
use ping, trace route, FTP/HTTP, or the web browser.
The parameter soft keys appear.
– IPoE is IP over Ethernet
– PPPoE is PPP over Ethernet
– Bridged Ethernet - HST acts as a layer two bridging
device between the WAN and LAN (no routing). This is
only available in Through mode.
– Multi-VLAN - Multiple Virtual LANs are used on this
network. In this mode, the HST assumes that the
networks that are accessed via each VLAN are
unique, and thus provides access to a different range
Chapter 2 VDSL Testing
Testing Data services
navigation key.
37