Connecting To The Line - JDS Uniphase HST-3000 User Manual

Connecting to
the line
6 Press the 5 key, and then specify the Upload Content,
either Pseudo-random or Fixed Pattern - AA55.
7 Press the 6 key, and then select an HTTP Authentication
configuration.
– None – no user name/password authentication
needed
– Basic – the client sends the username and password
entered, with no security
– Digest – the client sends the user name and password
in a series of hashes for added security.
The FTP/HTTP (throughput) settings are specified.
After specifying the test settings, you can connect to the line.
To connect to the line
1 For Terminate mode, connect as described on
or page 27.
2 For Through mode, connect one end of the test cable to
the 8-pin jack on the right-hand side of the HST-3000.
3 Connect the other end of the cable to Tip and Ring using
either the modular jack or clip leads.
4 Connect to the CPE:
HST-3000 VDSL Testing User's Guide
Chapter 2 VDSL Testing
Testing Data services
page 18
Ethernet port
Line
or
port
for
NID
Wall
jack
49