Connecting To The Line - JDS Uniphase HST-3000 User Manual

Connecting to
the line
Setting
ES H
(only on Pair Set-
tings menu)
SES H
(only on Pair Set-
tings menu)
UAS H
(only on Pair Set-
tings menu)
The bonding thresholds are specified.
After specifying the test settings, you can connect to the line.
To connect to the line
1 Using the "Y" cable, connect the single end of the test
cable to the jack on the side of the module.
2 Connect the other ends of the cable into the modular
connectors Modem 1 and Modem 2 on the NID, or use
clip leads to clamp pins 4 and 5 as shown below.
The test leads are connected.
HST-3000 VDSL Testing User's Guide
Testing in bonded modem emulate mode
Description
The highest allowed number of
Errored Seconds.
The highest allowed number of
Severely Errored Seconds
The highest allowed number of
Unavailable Seconds
Bonded
VDSL
Line
Line
port
Chapter 2 VDSL Testing
4
Modem 1
5
NID
4
Modem 2
5
N
E
T
W
O
R
K
27