Table of Contents
Advertisement
2.
The friction of the driver ( 1) –VI
is too small. For correction see the
INSTRUCTIONS under V-2
XI
THE NEEDLE TURNS THE PLATE WHEN THE P U ARM IS MOVING FROM THE OUTLET TO THE
SUPPORT ON THE SWITCH
This can only occur with 9 or 10 plates on the turntable . The cause is that the PU arm does not rise
sufficiently. In the highest position, the PU ARM must be horizontal. This can be set by the rom/BRAKE
disk
(1) with a spanner to turn c ounterclockwise . In this case, loosen the locking nut after a while.
R 15592
54
Advertisement
Table of Contents
