Table of Contents
Advertisement
left screw A/78
middlescrew C/45 right screw B/33-1/3
9. S etting the roller on the control disc..
In order to obtain a good operation of the mechanism, this roller (137) must be accurately adjusted. The
force to slide the roll through the slot is 275-300 grams. This force can of course be measured with a
measuring instrument,
b ut another method is this
:
Determine the weight of the control disc without the parts for the roll and weight the command disc to
275-300 grams. Now apply the roller and adjust so that the disc + weights slowly lower through the
grove/ slot when the roller is securely held.
18.
...................................................................
AG 1000
PARTS LIST
...ONLY INTERESTING PARTS SELECTED TO TRANSLATE
.........................................................
SHORT CENTER PIN..... Ophangveer Korte centrumpen....................
Pulley 60 Hz) ATTACHES TO MOTOR SHAFT VIA SET SCREW
Pulley 50 Hz)
power frequency Pulley 40 Hz) Set screw
....................... END PARTS....................FIG 1 THRU 9
...................................................................................................................................................
40
Advertisement
Table of Contents
