Table of Contents
Advertisement
rest position, the dead stroke must not exceed 0.5 mm. The roller (68) resting against the cam disc must
rotate at the same time. Allow the mechanism to make a change use the thumb to press the change
pins. The thumb must be pushed aside.
P15b
6. Setting the repeat mechanism
A. The point of the locking hook ( M fig.8 ) must be against the
point of the latch strip (74). This can be adjusted with the adjustment plate (G fig. 8) which is attached
with 2 screws.
The control disc must be in the h ome/rest position and
the p late printer in the rest groove.
B. The spindle/pin (D fig.9) on the control disc must be the bracket of
touch the locking hook in such a way that the repeat button then returns under the influence of the
horseshoe spring . So press the repeat button and check it . By the tired
to bend [
T his can be
corrected
by bending the stirrup.]
C. The upper part of the center pin can now be rehearsed
The upper art of the spindle do not move or very little (0.5 mm).
7. Set up the gramophone listener
....................................................................
7. A djusting the phono sensor
A. I n the first place, the sensor head must now be fitted
Make sure that the head fits tightly and stays in the 2 positions without deadlock ( this only applies to a
head with a double needle) .
36
Advertisement
Table of Contents
