Table of Contents
Advertisement
I.
Contrôle.
Turn the control disc to the h ome/rest position . The probe/TASTER
must now rest on the
a control disc ).
In the position of change...
Do not jump backwards in the switch position by tapping and knocking . Now place the
probe/TASTER backwards and check the entire operation of just a few 3 0 cm plates .
p13b
3.
Setting the stop position of the
(see fig.4a)
Place the disc changer in the [
control disk knock-out opposite the main shaft). Position the device vertically so that the
intermediate wheel
43 wheel rubber
is. Below ...
Then loosen the t wo fastening screws of the l ocking clip (135) fig.9 a few turns.
The locking clip can now be moved back and forth. Now the mold (see fig. 4a) must be clamped
around the main shaft, as shown in the figure. The locking bar must now be moved so that the roller
(8) rests against the center of the cam/ridge 4a and at the same time the pumping of the nose (3)
m ounting
plate
. The turntable is now turned clockwise (coupled with
n on
toothed
( fig.7) no item in either fr or dutch pdf...guess rol
c ontrol disc .
] rest position ( t he toothless part of the
32
Advertisement
Table of Contents
