Table of Contents
Advertisement
P12B
11-10-18 Removed whole taster assem ..all pieces were bent and out of whack..especially taster and mounting plate
Still don't know particulars of the taster finger at the control disc teeth !!!
A.
the control disc/ in the h ome/rest position and the P.U.arm
P lace
pressed sideways) on the switch. U nscrew the
press [ 62]FIG 8 is located in the rest groove . Take out the center pin / SPINDLE. Now p ush back? [ the
lifting s trip [
L ONG spring was removed
( K fig.8 ) against the roller l ( 1 23 fig 9 ) (in opposite direction ?). The lifting strip must again slide slightly
along with it. A distance of approx. 0 .3 mm remains between the rounding of the lifting strip and the
sloping side of the lifting disc ( 82)FIG 8. The
screws ( C fig.8 ) can now be tightened.[
of the
2 screws
] ( B fig.8 ) completely and the bracket
w hen were the 3 screws C fig 8 loosened?] parts show 3; I see only one
l eaf
A fig.6
(
) . The LARGE FLAT disc
30
Advertisement
Table of Contents
