Table of Contents
Advertisement
When the needle l ands outside the
, screw (
site
1)
must be screwed in a bit further (so turn right). If
the needle e nters too far into the
plate
, the screw (
1)
must be turned counterclockwise. Usually the
screw will only have to be slightly twisted. After adjusting, the screw must be secured with the lock
nut or with a lock lacquer.
IV
The needle does not end up in the inlet groove of a 17,5CM PLAAT
NOTE:
T HIS PIVOT BUSHING/POST IS THE ONE THAT HAS BEEN BENT SOMEHOW!!
664/5000
To correct this, the position of the front (1) must be corrected on the small steering hook . The
bending must be done in the curved part. When the needle lands outside the plate, the spring must
be bent so that the distance between the free end of the spring and the minor steering beacon is
greater. If the needle enters too far into the plate, the spring must be turned in the opposite direction.
-
45
Advertisement
Table of Contents
