Table of Contents
Advertisement
Below are a few more comments.
Motor:
The distance between rotor and stator is approx. 0 .2 mm , so that the rotor can be centered with small
shims of that size.
Pick-up arm:
The pick-up arm is clamped to the hollow shaft of the caliper spring/steering hook with the clamping
bracket ( 93) FIG 8 .
Pick-up bearing:
By removing the adjusting ring ( 9 0) FIG 8 . , the entire steering hook can be removed.
for the
b earing
balls
P laten-printer:
By loosening the fastening screws at the foot of the disc-press/plate presser, it can be removed. After
removal of the clamping ring ( 1 03) FIG 8 , the guide rod can be pushed out of the ball bush.
Mechanism:
After removal of the turntable ( C clip / clamping r ing 64 ) F IG 8, the entire mechanism can be removed by
removing the 3 nuts.
In advance, the various connections must first be disconnected. The top plate ( N fig. 8 ) can be moved in
the direction of the main axis/ shaft thanks to the oblong/slotted holes. In order to prevent deformation
of the main axis, when the platform is pressed, the distance between main axis and plate must be as
small as possible.
and also the spacer falls out
7 0 FIG 8
W atch out
25
Advertisement
Table of Contents
