Table of Contents
Advertisement
For the elimination of certain disruptions in the device, reference is also made to " Brief adjustment rule
for PHILIPS plate heat exchanger AG 1000M.
P11b
IX. S etting the record changer.
The setting rule described below must be used w hen a changer has been disassembled for repair . It can
at the same time serve to check a changer if it does not meet the set requirements.
In the following, it is assumed that the following parts are
. and p30 the two large LONG tension springs
SEE ALSO 2.B
-***
(81) and (75) - the horseshoe spring for the feeler ( 22)FIG 6 - the stop spring for the feeler ( 21)FIG 6 -
the pick-up head.
Furthermore, the device is moved b y hand unless it is indicated that the mains voltage must be
connected.
Sequence of the topics described:
1. The RECORD/plate printer. F IG 8 P22/P23
2. Adjust the lifting bracket and the RECORD F IG 6 18-22 P24/P25
3 . S etting the STOP/lock position of the CONTROL disk.
4. Setting the start-stop mode.
5. Setting the stroke of the center pen.
6 . Setting the REPEAT MECHANISM
7 . Setting the PHONO SENSOR
8. Setting the speed. [NUMBER OF REVOLUTIONS]
9. Setting the ROLLER ON THE CONTROL DISC.
n
ot
mounted:
F IG 8
26
Advertisement
Table of Contents
