Table of Contents
Advertisement
When the button is in position 10 "-12" (25-30cm), the changer is suitable for playing discs of those
diameters.
Plays with this diameter can be played in position 7 "(17.5 cm)
Control KNOB C:
REJECT>>START>>> STOP
1.
E lement/ Socket with d ouble needle (AG3005). By the unit
The " M " can be placed in front of the stripe on the arm, in which case the unit is set for playing
micro-grove discs, if the pick-up head is turned to N , then plates with normal groove can be used.
2.
Sensor head with single needle. This head can be compared to
the pick-up arm only occupy one position. Here it depends on the type used, which discs can be played
with this (see overview of sensor heads under Chapter I).
PALPE/Taster/feeler/probe E:
[ ... 'E ' remains LATCHED until a disc/record is ready to drop ["CHANGE"...]
W hen a 30 cm plate is placed on the turntable from the shoulder of the center pin, the
palp/probe/feeler /taster is pushed backwards [
upwards towards the P U
is controlled, so that the needle
in the inlet/first groove of this plate.
The plate printer/platendrukker item 62 fig 8
This part performs two functions, namely
Keep the plates h orizontal , which is at the center pin,
1.
To automatically s witch off the disc changer at the ending of the last record.
2.
From the above it appears that the position of
this must be taken into account. [
p5a
After the plates to be played have been placed on the shoulder of the center pin and t he plate press has
been pushed over the center pin, the record changer is ready for use.
This allows the machine to be
>>> FWD >>>
ARM]. As a result, the mechanism for the horizontal movement of the sensor
w here is D
?..there is a D
s tarted
and stopped.
t he taster finger near the control disc teeth pivots
F:
A , B and D
depends on the plates to be played, so that
on fig 8
12
Advertisement
Table of Contents
