Table of Contents
Advertisement
now connect the mains voltage and bring the P.U.arm above the turntable. The
G.
here in the rest position. S tart,the motor and then move the lever to the stop/off position. The
steering hook must now be locked behind the stop caliper/bracket,
when further turning
P15a
5.
Adjusting the stroke of the center pin
Move the control Disk to the home/rest position and the
A.
in the rest groove. Position the center pin so that the bottom end falls into the groove of the insert. Now
unscrew the 2 screws of the locking plates ( f ig.8 ) and the 2 screws of the locking plate ( F fig.8) Now
insert the
l arge spring (75
each other by sliding this sleeve onto the pin (A 9600.14.0 in parts list). Push one locking plate to the left
and the other to the right and now tighten the 2 screws so that the lower end of the center pin is
closed/locked without play.
Now remove the spring and the bush again.
B. Place the control disk in the change mode.
The 2 rollers on the
Control disk and the latch strip f acing each other . Press the locking strip in the direction of the control
disc axis of the control disc and then press the locking plate against the shaft of the control
disc and screw it in that position.
C
R einstall the spring ( 75)..see
.
To the h ome/ rest position . Place the [central spindle] center pin. This should be easy to take out and
take out in both the rest and the change position. In the change/ switch position, the shoulder must fall
completely within the pin and in the
. Check this at 78 and 33 1/3 rpm.
) and insert the 2 cylinders of the center pin w ith tools (see fig. .4 ) in line with
b ut should not be pulled out
p late press
p21
and rotate the control disc
p lates printy
35
Advertisement
Table of Contents
