Casio IT-800 Series Software Manual page 63

BARWIDTH
MARGINCHECK
LEARINING
Notes:
1. To set up multiple bar code symbologies effect, specify a sum of the symbology values you
wish to scan.
2. To set up multiple output methods effect, specify a sum of each value of the output methods
you wish to set. However, if you set "GS1-128 without Full ASCII conversion", "GS1-128
with code ID attached" and "GS1-128 Fnc → GS conversion" effect at the same time,
"GS1-128 without Full ASCII conversion" has the priority over the other settings. Thus, the
settings are disabled.
3. Since Gun-trigger key is not integrated in the terminal, the key value is ignored.
4. A.I. is the abbreviation of Application Identifier which is attached at the forefront of bar code
of GS1 DataBar Omnidirectional, GS1 DataBar Limited, and GS1 Stacked symbologies.
5. Setting up the scan width control function in one of four modes while the setting gain is set up
in Auto mode may cause a deterioration of scanning bar codes that are printed in a poor quality.
If you need to set up the scan width control function, select the setting gain in Mode 0 to Mode
3. Or, if you select the setting gain in Auto mode, select the scan width control function in "No
control on laser beam emission width" mode only
The functions of the Laser Scanner Library relevant to the Configuration File are as follows.
OBRSaveConfigFile
OBRLoadConfigFile
OBRSetDefaultSymbology : Sets up default status of the Laser Scanner driver.
Setting correction value
of thickness of bars
Setting threshold values
for right and left margins
Setting learning mode
: Saves all settings for the scanner driver into the configuration file.
: Retrieves and then loads the configuration file into the scanner
driver.
63
0 0 0: No correction
1 1: Thin black bar
2 2: Thin black bar (or
thicken black bar)
3 3: Thin white bar
4 4: Thin white bar (or
thicken white bar)
0 0 0: Maximum
1 1: Middle
2 2: Narrow
3 3: Minimum
0 0 0: Disable
1 1: Enable