Casio IT-800 Series Software Manual page 39

2.2.3 Scan Parameters
Conditions that allow scanning a symbology in a specific mode can be set for each readable
symbology.
Readable Symbology
Bar code symbologies that are enabled or disabled for scanning can be specified. If only specific
symbologies are to be scanned, set "Enable" for scanning on these symbologies only and
"Disable" on other symbologies. This saves decode processing time and lowers error rate. The
default is "Enable scanning on all the symbologies".
Readable Digits
The no. of readable digits can be set for each symbology. If only specific no. of digits is to be
scanned, specify it for each readable symbology. This saves decode processing time and lowers
error rate.
Enable or Disable Check Digit
Check digit can be set to "Enable" or "Disable" for each readable symbology. Setting the check
digit lowers error rate.
Table 2.28
EAN, UPC-A, UPC-B
EAN, UPC-A, UPC-B Addon
UPC-E
UPC-E Addon
Code39
NW7
Interleaved 2of5
Industrial 2of5
Code93
Code128
MSI
IATA
GS1 DataBar Omnidirectional
GS1 DataBar Limited
GS1 DataBar Expanded
GS1 DataBar Stacked
GS1 DataBar Expanded Stacked
Symbology Check Digit Calculation
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable
Enable
Enable
Enable
Enable
39
Default
Enable
Enable
Enable
Enable
Disable
Disable
Enable
Enable
Enable
Enable
Enable
Disable
Enable
Enable
Enable
Enable
Enable