Termination Codes - Casio DT-X7 Series Software Manual

Table 2.37 MSI symbology
D Data
C Mo10, Mod11 check digits. Becomes data when there is no check digit
attached. (note)
Note:
The DT-X7M10U does not support MSI symbology without mod10 check digit or mod11 check
digit.
Table 2.38 IATA symbology
D Data
C Check digit (IATA). Becomes data when there is no check digit attached.
P Coupon number
A Airline number
Table 2.39 RSS-14 symbology
D Numeric data
C Mod10 check digit
Table 2.40 RSS Limited symbology
D Numeric data
C Mod10 check digit
Table 2.41 RSS Expanded symbology
D Numeric data
A Alphabet data
The functions of the Laser Scanner Library relevant to the "Scanning Output Formats" are those
listed on page 47.

Termination Codes

Choose one of the following five termination codes to attach to the end of decoded data.
- CR
- LF
- CR+LF
- TAB
- No termination code (default)
The functions of the Laser Scanner Library relevant to the "Termination Codes" are as follows.
OBRSetSuffixChar
OBRGetSuffixChar : Retrieves suffix control code appended to decoding data.
: Sets up suffix control code appended to decoding data.
54