Configuration File - Casio DT-X7 Series Software Manual

Notes:
•
The DT-X7M10U does not support the gain control.
•
Setting up the setting gain in Auto mode while the scan width control function (see page 59)
is set up may cause a deterioration of scanning bar codes that are printed in a poor quality. If
you need to set up the scan width control function, select the setting gain in Mode 0 to Mode
3. Or, if you select the Auto mode of the setting gain, select the scan width control function
in "No control on laser beam emission width" mode only.
The functions of the Laser Scanner Library relevant to the "Setting Gain" are as follows.
OBRSetGainControl
OBRGetGainControl : Retrieves the gain control.

Configuration File

The various setting values can be stored in a file and resumed. The setting file storage location and
its name are "\FlashDisk\System Settings\OBRDRV.ini". If there is no such configuration file, the
default values are used to initiate the scanning.
The functions of the Laser Scanner Library relevant to the "Configuration File" are as follows.
OBRSaveConfigFile
OBRLoadConfigFile
OBRSetDefaultSymbology : Sets up default status of the scanner driver.
Table 2.49
Symbolo
Parameter
gy
READCODE
Continue.
: Sets up gain control.
: Saves all settings for the scanner driver into configuration file.
: Reads and loads the configuration file into the scanner driver.
Description
Enable or disable
scanning the
symbologies.
(note 1)
63
Range Default
1 131071 1:
2 2:
4 4:
8 8:
16 16:
32 32:
64 64:
128 128:
256 256:
512 512:
1024 1024:
2048 2048:
4096 4096:
8192 8192:
16384 16384:
32768 32768:
65536 65536:
Setting
Enable Code39
Enable NW-7
Enable WPC Addon
Enable WPC
Enable UPC-E Addon
Enable UPC-E
Enable IDF
Enable ITF
Enable Code93
Enable Code128
Enable MSI
Enable IATA
Enable RSS-14 (note
7)
Enable RSS Limited
(note 7)
Enable RSS Expanded
(note 7)
Enable RSS-14
Stacked (note 7)
Enable RSS Expanded
Stacked (note 7)