Scanning Parameters - Casio DT-X7 Series Software Manual

2.2.3 Scanning Parameters

Conditions that allow scanning a symbology in specific mode can be set for each readable
symbology.
Readable Symbology
Bar code symbologies that are enabled or disabled for scanning can be specified. If only specific
symbologies are to be scanned, set "Enable" for scanning on these symbologies only and
"Disable" on other symbologies. This will reduce decode processing time and lower the error rate.
The default is "Enable scanning on all the symbologies".
Readable Digits
The no. of readable digits can be set for each symbology. If only specific no. of digits is to be
scanned, specify it for each readable symbology. This will reduce decode processing time and
lower the error rate.
Enable or Disable Check Digit
Check digit can be set to "Enable" or "Disable" for each readable symbology. Setting the check
digit will lower the error rate.
Table 2.27
EAN, UPC-A/B
EAN, UPC-A/B Addon
UPC-E
UPC-E Addon
Code39
NW-7
Interleaved 2of5
Industrial 2of5
Code93
Code128
MSI
IATA
RSS-14 (note 2)
RSS Limited (note 2)
RSS Expanded (note 2)
RSS-14 Stacked (note 2)
RSS Expanded Stacked (note 2)
Notes:
1. DT-X7M10U does not support "Disable" with the symbology.
2. The RSS symbologies change its name to "GS1 DataBar".
RSS-14 → GS1 DataBar Omnidirectional
RSS Limited → GS1 DataBar Limited
RSS Expanded → GS1 DataBar Expanded
RSS-14 Stacked → GS1 DataBar Stacked
RSS Expanded Stacked → GS1 DataBar Expanded Stacked
Symbology Check Digit Calculation
Enable or Disable (note 1)
Enable or Disable (note 1)
Enable or Disable (note 1)
Enable or Disable (note 1)
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable
Enable or Disable (note 1)
Enable or Disable (note 1)
Enable or Disable
Enable
Enable
Enable
Enable
Enable
47
Default
Enable
Enable
Enable
Enable
Disable
Disable
Enable
Enable
Enable
Enable
Enable
Disable
Enable
Enable
Enable
Enable
Enable