Casio DT-X7 Series Software Manual page 127

2.8.2 Power ON Factors
The following is the power ON factors. These factors can be set enabled or disabled using the
System Library.
• The Power key is pressed while the power is off.
• A time period set for the Alarm function elapsed.
• The terminal is mounted on cradle while the power is being supplied by AC adaptor via the
cradle.
• Trigger key is pressed.
• WakeOn call is issued by the Bluetooth module.
• VDET1 occurred while the WakeOn function has been set enabled.
• Reset switch on the back of the terminal is pressed.
The functions of the System Library relevant to the "Power ON Factors" are as follows.
SysSetBootup
SysGetBootup : Retrieves "Enabled" or "Disable" status for turning on the power.
Power ON Disable Factors
Factors that do not allow turning on the power are as follows.
• When the battery pack's voltage level is not sufficient enough to start up the terminal (VDET2
level or less).
• The battery cover lock switch in the battery compartment is open.
: Sets up "Enable" or "Disable" for turning on the power.
127