Laser Setting - Casio DT-X7 Series Software Manual

3.21 Laser Setting

This applet (applicable to DT-X7M10E, DT-X7M10R, DT-X7M10R2, DT-X7M10E-CN,
DT-X7M10R-CN, and DT-X7M10R2-CN) is to change the settings for the integrated laser
scanner. For detail about each parameter, refer to Chapter 2.2 "Laser Scanner".
Read barcode Tab
This tab is for specifying bar code symbologies to scan. Multiple symbologies can be specified.
Figure 3.108
Driver Mode Tab
This tab is to set up "Enable" or "Disable" for scanning each symbology of the symbologies listed
in Laser Setting tab and its parameters listed below.
- Min (No. of minimum readable digits)
- Max (No. of maximum readable digits)
- Output format
- Check-digit
- Check-digit output
Figure 3.109
221