Danfoss VLT AutomationDrive Manual page 42

®
VLT AutomationDrive EtherNet/IP
(12-98) Interface Counters
Range:
In Octets
In Unicast Packets
In Non-Unicast Packets
In Discards
In Errors
In Unknown Protocols
Out Octets
Out Unicast Packets
Out Non-Unicast Packets
Out Discards
Out Errors
Function:
Read only.
Advanced Interface counters, from build-in
switch, can be used for low-level trouble-
shooting,
The parameter shows a sum of port 1 + port 2.
(12-99) Media Counters
Range:
Alignment Errors
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Errors
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
Function:
Read only.
Advanced Interface counters, from build-in
switch, can be used for low-level trouble-
shooting,
The parameter shows a sum of port 1 + port 2.
- P a r a m e t e r s –
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
MG.90.Jx.02 ver. 5 th September 2007 – VLT is a registered Danfoss trademark
42