Introduction; About This Manual - Danfoss VLT AutomationDrive Manual

®
VLT AutomationDrive EtherNet/IP

Introduction

About this Manual

First time users can obtain the most essential information for quick installation and set-up in these
chapters:
Introduction
How to Install
How to Configure the System
For more detailed information including the full range of set-up options and diagnosis tools please
refer to the chapters:
How to Configure the System
How to Control the FC 300
How to Access FC 300 Parameters
Parameters
Troubleshooting
Terminology:
In this manual several terms for Ethernet is used.
- EtherNet/IP, is the term used to describe the CIP/ODVA application protocol.
- Ethernet, is a common term used to describe the physical layer of the network and does not
relate to the application protocol.
MG.90.Jx.02 ver. 5
th
September 2007 – VLT is a registered Danfoss trademark
4