Running A Test Fold; Fold Skew Adjustment; Ready To Fold; Stopping The Folder - Martin Yale 2051 Installation Operation & Maintenance

Martin Yale 2051 Folder
®
2.4

Running a Test Fold

The "TEST" button provides the ability to check the folder settings by feeding 2 sheets of
paper from the Feed Table. Pressing the "TEST" button once will turn on the main motor,
feed two sheets of paper, and then the main motor will stop.
Folders with older revisions of software will only feed a single sheet of paper when
the Test button is depressed.
If the location of the fold is incorrect, adjustment of the Fold Tables is required. See section 3.2 -
Fold Table Adjustment.
If the fold is not square (skewed fold), adjustment to the paper guides is required. See section 0 -
Fold Skew Adjustment for more information.
2.5

Fold Skew Adjustment

Skew adjust of the fold is done by changing the angle of
the Paper Guides in the Feed Table. Skew adjustments
can be made at any time, regardless of paper load in
Feed Table, or if the folder is running.
To adjust, rotate the Skew Adjustment Knob located on
the side of the Feed Table, closest to the front on the
folder (Figure 15).
While the folder is running, as each sheet of paper
feeds into the machine, if you observe the paper riding
up on the front Paper Guide (closest to the Operator
Interface), rotate the Skew Adjustment knob counter-
clockwise until the paper is feeding straight and is not
riding up the Paper Guide. Rotate the knob clockwise if
the paper is riding up on the rear Paper Guide.
2.6

Ready to Fold

Pressing the "RUN" button will initiate folding – the main motor will start and paper
feeding will begin. Feeding will continue until one of the follow conditions is met; 1. The
"STOP" button is depressed, 2. The Feed Table becomes empty of paper, 3. A folding
error is encountered, 4. Or the programmed quantity reaches 0 (zero).
To program the quantity of sheets to be folded, see section 3.6 - Quantity and Batch Mode.
2.7

Stopping the Folder

Pressing the "STOP" button once instructs the folder to perform a normal shut down,
allowing all paper to clear the folder prior to the main motor stopping.
Depressing the "STOP" button twice in quick succession causes an immediate stop of the
main motor. This is to be used in the event that there is a paper jam that the folder did
not detect, or other condition where an instantaneous stop is necessary.
Double pressing of the "STOP" button is reserved for emergency stopping only, and should
not be used for normal stopping when the folder is running.
Revision 3.0 Martin Yale Industries, Wabash, Indiana, USA 260-563-0641
(2051.09.03.16.11.40)
Figure 15
Figure 15
Page 11 of 52