Stack Wheels; Option 6 - Fold Counters; Cltch Cnt (Clutch Count); Age Count - Martin Yale 2051 Installation Operation & Maintenance

Martin Yale 2051 Folder
®

7.6.3 Stack Wheels

To move the Stack Wheels, press the Stack Wheel button, and then press either the "+" or "-" button.
The display will show the analog sensor reading (A/D) from the Stack Wheels, and it will show the
position of the Stack Wheels in either inches or centimeters (depending on the current units set).
Option 6 – Fold Counters
7.7
This mode will display an age reference of the folder. There are 2 different values displayed in this
mode; Clutch Count and Age Count. These counters provide a means of tracking the age and the
amount of use that the folder receives.
In the event that a Tech Support call is required to Martin Yale, the Clutch Count and Age Count of
the folder will be required.

7.7.1 CLTCH CNT (Clutch Count)

This value shows the number of times that the clutch has fired since it has last been serviced. In this
case, "serviced" means either R&R or maintenance performed in the field by a qualified technician,
such as a Clutch replacement, or a Fold Table Drive replacement. The Clutch Count is meant to be
reset anytime work is performed on the folder.
To reset the Clutch Counter, depress and release the following buttons in sequence; "CE", "0",
"STORE".

7.7.2 Age Count

This value shows the number of clutch firings that have occurred since the machine has been built and
first shipped from the factory. This value cannot be reset in the field, and is not meant to be reset. If
the Main Controller PCB is replaced, the age of the folder will be lost.
Option 7 – Output Limits Mode
7.8
This mode is used to define the various required operating parameters that the folder uses to function
correctly. There are 6 different parameters that must be "taught" to the folder; Fold Table Offset #1,
Fold Table Offset #2, Paper Diverter Engagement Distance, Stack Wheel Home, Stack Wheel
Maximum and Fold Position Center.
7.8.1 Fold Table Home - #1 & #2
To teach the folder where both Fold Table home positions are, perform the following steps.
1. Install both Fold Tables.
2. Turn the power on and allow both Fold Tables to go to
their respective home positions. ONCE IN HOME
POSITION, DO NOT SELECT A FOLD TYPE!
3. Load several sheets of 8 ½ x 11 (or A4) 20# paper into
the Feed Table and press the "TEST" button, which will
fold two sheets of paper.
4. Depress and hold the "STOP" button until the folder
enters diagnostics mode.
Revision 3.0
CLTCH CNT:
AGE COUNT:
Martin Yale Industries, Wabash, Indiana, USA 260-563-0641
Figure 28
(2051.09.03.16.11.40)
Page 21 of 52
Figure 29