Adjusting And Counting; Incremental Adjustment Buttons; Fold Table Adjustment; Stack Wheel Position - Martin Yale 2051 Installation Operation & Maintenance

Martin Yale 2051 Folder
®

3 Adjusting and Counting

Pressing any of the following buttons will place you into the respective adjustment mode. If you do not
press any other buttons for 8 seconds, the folder will revert to its previous mode.
Pressing the Enter button will bypass the 8 second time delay and will instantly proceed.
3.1

Incremental Adjustment Buttons

The Incremental Adjustment Buttons are used for fine adjustment of various
items on your folder. These buttons work for all of the functions that have the
matching light-blue background color only. These buttons will auto-repeat if
held down for more than one second.
3.2

Fold Table Adjustment

To manually adjust a Fold Table position, press the corresponding Fold Table
adjustment button as shown below, and then press either the increase or
decrease button (as described in section 3.1 - Incremental Adjustment Buttons).
In addition to the Incremental Adjustment buttons, the Fold Tables can be
positioned to a specific location by entering a value using the number buttons on
the keypad. To do so, simply type in a value and press the enter button.
If you find it necessary to make an adjustment to either fold table when you
have a standard fold type specified, changing the Fold Table by more than 1/4 of
an inch will place the folder into "manual" mode, as indicated by the illumination
of the "Other" LED. Moving the fold table back to within 1/4 of an inch will turn off
the "Other" LED and the standard fold type LED will again by illuminated.
Your folder is equipped with a "Limp" mode. In the event that either Fold Table Drive malfunctions
(see error codes 105, 106, 107, or 108), you can still move the fold table manually and run the folder.
For more information regarding "Limp" mode, see section 6 - Limp Mode.
3.3

Stack Wheel Position

To manually adjust the position of the Stack Wheels, press the Stack Wheel button
(shown on the left), and then press either the increase or decrease button (as described in
section 3.1 - Incremental Adjustment Buttons).
The correct position of the Stack Wheels is automatically calculated based on the length of the
paper and the position of the fold tables. Manual adjustment of the Stack Wheels is not normally
required when performing a standard, pre-programmed fold.
Revision 3.0
Fold Table 1
Fold Table 2
Martin Yale Industries, Wabash, Indiana, USA 260-563-0641
XX.XX IN
Figure 16
XX.XX IN
Figure 17
(2051.09.03.16.11.40)
First Fold Table
Second Fold Table
Page 12 of 52