Table of Contents
Advertisement
3.6
Right Angle and Baronial Fold Setup
Please follow these instructions for setup of the Right Angle and Baronial
folds.These two folds are not listed on the simplified folding chart. They
can be accomplished in two steps.
1.
Step one will be done automatically as in Section 3.5 for a Single Fold. Fold all the paper in half before pro-
ceeding to step two.
2.
Step two will be done manually, one sheet at a time as in Section 3.7 Multi-Sheet Fold Set-up. Push the
bypass lever and slide the single folded sheet under the Feed Wheel and into the rollers. Attempting to
auto-feed stacks will result in jamming.
3.
Step two for a Right Angle fold, adjust the 1st Fold Table for a single fold.
4.
Step two for a Baronial fold, adjust the 1st and 2nd Fold Tables for a tri-fold.
3.7
Multi-sheet Fold Setup
Please follow these instructions for folding multiple sheets. The Feed Table is equipped
with a Bypass Lever which allows the Retarder Assembly to be pushed away from the
Feed Wheel, thereby permitting multiple sheets to be fed directly into the fold rollers.
1.
Set up the desired fold as described in section 3.5.
2.
With the folder OFF, push and hold the Bypass Lever forward with one hand then pass the multiple set of
paper under the Feed Wheel until it contacts the fold rollers. Note: if using stapled multiple sets, be
sure to attach staples horizontally to the fold rollers and feed the stapled end last.
3.
Press momentary (I) to turn the folder on long enough to complete the fold. Repeat steps 2 and 3 for each
multi-sheet fold.
Note: Do not exceed the recommended number of pages or attempt to hand feed with the machine run-
ning as skewing and jamming will likely occur!
4.0
Maintenance
4.1
Feed Wheel
After a period of normal operation, the Feed Wheel will become coated by ink, toner, lint, and other contaminant.
Clean the Feed Wheel by wiping with a damp cloth containing a mild soap and water solution. CAUTION: Do not
use rubber roller cleaner or other solvents on the Feed Wheel. To maximize the gripping power of the Feed
Wheel and to remove any remaining contaminant, go over the Feed Wheel surface with medium grit emery cloth.
Replace the Feed Wheel when, with a properly adjusted Retarder Assembly, a single sheet will no longer feed suc-
cessfully.
4.2
Folding Rollers
During normal operation, the Folding Rollers will become coated with ink, toner, lint, and various other contami-
nant. Contaminated Folding Rollers can cause a variety of folding problems. We recommend cleaning the Folding
Rollers after every folding job, according to the following procedure. Regular cleaning will ensure optimum perfor-
mance and add years of life to the Folding Rollers.
1.
Make sure that the power to the machine has been disconnected and locked out.
2.
Remove the Feed Table Assembly, the 2nd Fold Table Assembly, and the Roller Cover.
(7)
Right Angle
Fold
Bypass
Lever
Baronial
Fold
Advertisement
Table of Contents
