Setting The Paper Guides; Setting A Paper Size; Setting A Fold Type - Martin Yale 2051 Installation Operation & Maintenance

Martin Yale 2051 Folder
®
Once the Feed Table has been loaded with paper, depress the
Feed Table Release to unlocked the Feed Table, allowing it to
return to the raised position (Figure 13).
It's important to understand that the Feed Table rises up
using spring tension, and this tension is pre-set to lift a 500
sheet stack of 8 ½ X 11, 20# Bond paper. If loading coated
stock (dense paper) or paper that is larger than 8 ½ X 11, you
will not be able to fully load the Feed Table with 500 sheets of
paper.
2.1

Setting the Paper Guides

To adjust the Paper Guides, loosen the thumb knobs of the
Paper Guides by rotating the knobs counter-clockwise (top to
the left) approximately 1 full turn (Figure 14). Move the Paper
Guides to the desired location, and then retighten the thumb
knobs.
Do not over tighten the thumb knobs.
Tighten the thumb knobs just enough to hold the Paper Guides
in place. Do not use any tools to tighten the thumb knobs as
this will damage the knobs and the Paper Guides.
When setting the Paper Guides, it is easier to have the
correct paper in the Feed Table between the guides as you
adjust them. Also, it is easier to move the Paper Guides with
your left hand from under the Feed Table, rather than from the
top by grabbing the Paper Guide itself.
For best folding results, the paper should be as close to centered on the Feed Table as possible.
2.2

Setting a Paper Size

To change paper sizes, depress the "SIZE SELECT" button located on the folder keypad.
Each time the "SIZE SELECT" button is depressed, the lights indicating the paper size
will sequence through all of the paper sizes.
You must specify the paper size that you intend to fold prior to running the folder.
2.3

Setting a Fold Type

To change the fold type, depress the "FOLD SELECT" button located on the folder
keypad. Each time the "FOLD SELECT" button is depressed, the lights indicating the fold
type will sequence through all of the fold types.
Once you have selected a fold type, the folder will wait for 8 seconds, for any
additional settings that you may want to set, such as a quantity of folds to run. To bypass this time
delay, depress the "ENTER" button. Additionally, pressing either the "TEST" or "RUN" buttons will
bypass this time delay and then perform either "TEST" or "RUN", whichever was pressed.
Revision 3.0 Martin Yale Industries, Wabash, Indiana, USA 260-563-0641
(2051.09.03.16.11.40)
Figure 13
Figure 14
Page 10 of 52